AutoInspire Ltd are the leading provider of clutch replacement in Chesterfield area and a Valeo Clutch Expert Garage.
The Valeo Clutch Expert Program aims to ensure independent garages like Fourselves give a professional and reliable clutch wear checking, replacement and fitting service to all its customers.
Valeo only endorses garage that have the mechanical expertise and knowledge to fit the correct products first time. Giving technical support to fit even the most difficult of clutches.
With our endorsement from Valeo, you can be assured you and your vehicle are in safe hands with any clutch requirements at AutoInspire.
If you are unsure of the condition of your clutch or you think your clutch may need replacing, just call down to our garage where one of our technicians will carry out a free clutch health check and advise on the best possible options and provide you with a detailed quotation. No appointment needed, just show up at a time that suits you best.
Clutch replacement costs vary from vehicle to vehicle. As the prices of parts and labour differ on each vehicle. If you would like a quote for a new clutch or clutch wear checking, please either visit or contact us by email or phone where we will be happy to discuss pricing options.
With the introduction of dual mass flywheels into mainly diesel vehicles to reduce the vibration from engine to gearbox these items tend to wear out to, this can be a costly job to replace.
The symptoms of a worn out dual mass are vibration when driving or setting off.
Sometimes the fragments from the broken down flywheel block up the starter motor causing starting issues.
Ford Mondeos and transits are particularly bad for this, and just fitting a new starter motor will only cure the starting issue for a short period until the new starter motor gets blocked up.
But don’t worry, Valeo have introduce a four piece conversion kit that replaces the dual mass flywheel with a solid flywheel with a clutch that contains heavy duty springs which do the job the dual mass flywheel was installed to do.
The conversion kits include a solid flywheel which has no wearing parts so it will last longer than a dual mass flywheel. These kits work out cheaper than fitting another dual mass and it is something less to worry about.
The three main parts to your clutch are the friction plate or drive plate, the pressure plate and the release bearing. We sometimes get asked just to fit the item out of the three that is worn.
But with the labour times involved in removing the gearbox, this doesn’t make sense. Plus, all the old parts will be worn, so it is best to replace all parts while the gearbox is removed.
When the clutch is slipping, the material on the friction plate has worn down, so the friction cannot enable drive from the engine to the gearbox. Alternatively, it could be hard to select gears, so the pressure plate is not moving enough to allow you to engage in to gears.
The clutch is operating using a pedal within the vehicle, which can either be connected to the clutch via a cable or operated hydraulically via the displacement of clutch fluid.
Or during more recent times electronically controlled. If the cable or hydraulics fail, the clutch pedal with likely go down to the floor.
With a cable operated system, the cable has likely snapped and will need replacing.
If it is a hydraulic system, the concentric cylinder which forms part of the release bearing has probably burst a seal this is housed inside the gearbox which will need replacing.
A clutch in a vehicle is operated from inside the car via a pedal. By pressing and releasing the pedal, this motion engages and disengages the drive, allowing the engine to move torque into the gearbox allowing the car to move.